Kraun KR.UL Manuel d'utilisateur télécharger pdf (Page 17)

Manual

www.kraun.it

5.3.2. BYPASS OUTPUT SETTING

1. Enter the setting interface. Press and hold the

function setting key

for more than 2 sec-

onds, then come to setting interface, Press

and hold the function setting key

for

more than half a second(less than 2 seconds),

select the function setting, choose the bypass

output interface, at the moment, the letters

“bPS” will ﬂash as following:

2. Enter the Bypass output setting interface.

Press and hold the function setting key

for more than half a second(less than 2 sec-

onds), then come to setting interface of bPS,

at this time, the letters “bPS” will light for a

long time. The “ON” below the bPS will ﬂash.

Press and hold the inquiring key

for

more than half a second (less than 2 seconds)

to determine whether the bPS function is

used or not. If used, the corresponding word

is “ON”, if not, the word is “OFF”. It can be de-

termined by yourself.

3. Conﬁrm the Bypass output setting interface. After selecting ON or OFF, press and hold the function

setting key

for more than 2 seconds. Now, the bPS setting function is completed and the “ON”

or “OFF” below the “bPS” will light without ﬂash.

4. Exit from the setting interface. Press and hold function setting key

for more than 2 seconds, exit

from the setting inte

rface and return to main interface.

5. After setting bPS as ON, when mains power plugged in without turning on the UPS or no mains

power plugged in, there is bypass output but no power down backup function.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Pas de commentaire

Kraun KR.UL Manuel d'utilisateur Page 17